![]() ![]() This integration uses this callback to distribute ‘rflink packet events’ over Home Assistant’s event bus which can be subscribed to by entities/platform implementations. ![]() The rflink Python module is an asyncio transport/protocol which is setup to fire a callback for every (valid/supported) packet received by the RFLink gateway. ![]() If you find a device is recognized differently, with different protocols or the ON OFF is swapped or detected as two ON commands, it can be overcome with the RFLink ‘RF Signal Learning’ mechanism from RFLink Rev 46 (11 March 2017). If you have a device supported by RFLink but not by this integration please consider testing and adding support yourself. Device supportĮven though a lot of devices are supported by RFLink, not all have been tested/implemented. This configuration uses 0a0a0a to control the inverted shutter (send UP to close and Down to open) and listen commands sent by 0f1f2f remote control. # Example configuration.yaml entry for inverted RTS cover cover : - platform : rflink devices : # Rfloader created remote control which is used by Home Assistant RTS_0a0a0a_1 : name : " Blind office" aliases : - rts_0f1f2f_01 # ID of the remote control (Somfy smove in this case) type : inverted ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |